NDC announces new TempTrac Pro for Beta LaserMike in-process wire preheating systems

Beta LaserMike preheaters from NDC Technologies provide uniform, in-process wire heating to eliminate insulation voids in primary cables. When a wire is preheated for only fractions of a second by a low frequency of 50 to 60 Hz heat cycle, the heat is unevenly applied to the wire, resulting in hot and cold spots. Beta LaserMike preheaters solve this problem by using high-frequency preheating that applies the optimum heat cycles to the wire as it passes through the preheater. This ensures a linear and consistent heating along the length of the wire, regardless of speed, to meet unique temperature requirements.

‍

Now, Beta LaserMike preheaters can be equipped with the new TempTrac Pro non-contact temperature measurement system for high-accuracy monitoring and control of preheat temperatures. The TempTrac Pro sensor enables you to measure the preheat temperature of your wire and cable with the highest accuracy. It can measure wire diameters from 0.28 to 2.80 mm. The TempTrac Pro controller closes the loop to improve process efficiency and product quality while minimising waste. It can be provided as a stand-alone system or can be integrated with the Beta LaserMike preheater system. The line of measurement and control products are designed to increase productivity, improve product quality and reduce manufacturing costs.

Source: Wire Bulletin